Product testing footage and demonstrations.

The plate was tied to an empty plastic bucket to simulate impact feedback; the first two rounds of shooting failed to break the empty bucket.

7.62x39mm and .300 Blackout rounds struck the same point; a distinct indentation appeared on the back of the plate, but it was not penetrated.

The .44 Magnum round struck the rim of the plate and overlapped with the .45 impact, resulting in damage to the empty bucket positioned behind it.

The plate was mounted onto a wooden board and subjected to a full round of live-fire testing to determine whether it would be penetrated.

After four rounds of firing, slight surface indentations were observed, but no penetration occurred.

Fired multiple consecutive shots with a .45, but failed to penetrate.

The helmet was placed on a shooting target; after each shot, the size of the indentation on the back was inspected to determine whether it had been penetrated.

The helmet perfectly withstood the impact of the .45, but the .44 Magnum—fired from a long-barreled weapon—inflicted severe damage upon it.

Describe the In the final test, the helmet withstood one .300 blackout bullet, while another penetrated the helmet (normally, a 3A-grade helmet cannot stop any rifle bullets; the fact that it stopped a rifle bullet in this test was somewhat lucky and should only be taken as a reference).model, protection level, test setup, and key viewing notes shown in this video.

Place a pumpkin behind the plate to simulate blunt-force trauma following a shooting.

After the ballistic ceramic has shattered, fire at the exact same spot again to assess the defensive performance.

View the blunt force trauma results on the pumpkin after being shot.

A bulletproof chip is affixed to the front of a bucket to simulate whether the blunt force impact—following the defensive barrier—is capable of breaching the bucket.

After all the shooting was completed, the bucket was neither broken nor penetrated.

The bulletproof chip was placed in front of a wooden board; the test was conducted to see if it could be penetrated.

Describe the product model, protection level, test setup, and key viewing notes shown in this video.

The bulletproof vest was placed over an empty bucket to check whether it would be penetrated.

Check shooting results.

Placing the helmet on a tree branch to simulate an impact while standing.